Corona Site Mount Problem

clayflet

Grumbler in Training
Joined
May 8, 2013
Posts
11
I have a problem with my Corona Site Mount. Has power, vac works, but will not heat up. Anyone with one of these have any idea what the problem is and how to fix it?
 
I have a problem with my Corona Site Mount. Has power, vac works, but will not heat up. Anyone with one of these have any idea what the problem is and how to fix it?
Not really familiar with that model but does it have circuit breakers or fuses on the back like a DryTac?
Check the fuses if it has them or flip the breakers if it has those.

These are the breakers on the back of a DryTac press.
Your press may be completely different.
Screen Shot 2018-02-12 at 7.14.37 PM.png


We had the temperature sensor go bad on our DryTac and had a heating problem until we replaced the sensor.
As mentioned, I'm not familiar with a Corona and I'm just spitballing here.
Good luck.
 
Last edited:
Better than having the seal around the bed leaking. (don't ask).

You could get an electrician to give it the once-over. If you can id the offending part then as long
as you can get spares it would be relatively simple to replace it.

My monies on a heating element that has died. When they do this they will often blow the fuse.
 
Not really familiar with that model but does it have circuit breakers or fuses on the back like a DryTac?
Check the fuses if it has them or flip the breakers if it has those.

These are the breakers on the back of a DryTac press.
Your press may be completely different.
View attachment 28462

We had the temperature sensor go bad on our DryTac and had a heating problem until we replaced the sensor.
As mentioned, I'm not familiar with a Corona and I'm just spitballing here.
Good luck.
 
I replaced the fuse. Had an electrician look at it this morning. He thinks the control is bad. I think it has lived out it’s life. Parts are not available as far as I can see. Looking to replace it with something from this century.
 
Back
Top